Home 9 Skate Heat Molding

ADDRESS

House of Hockey, LLC
(Inside Verona Ice Arena)
451 E. Verona Avenue
Verona, WI 53593

PRO SHOP HOURS

*M-F 1:00pm – 7:00pm
*Sat 9:00am – 4:00pm
*Sun 9:00am – 4:00pm
Visit our FB Page for the most current up to date weekly pro shop hours. Click here.

* Hours are subject to change without notice and will vary depending on when we are on the ice for practices/games or away for games and weekend tournaments.

PHONE

+1 (608)-497-0422

EMAIL

[email protected]

SKATE HEAT MOLDING

Heat molding – aka “baking” new hockey skates is a method to help break them in faster so they fit your foot better and cause less pain during the break-in period.

OUR HEAT MOLDING SERVICE

Our skate oven is specifically designed for heat molding new hockey skates and our staff is trained in properly performing the heat molding process. You can expect to remain seated with your skates on for approximately 15 minutes during the process.

We’ll heat up your skates for 7-10 minutes before you put them on and lace them up.  You’ll then place your feet into our old school CCM Skate Compressor machine.  The skate compressor will inflate air bladders all around your skates, applying consistent and even outside pressure to help mold the skate boot while it cools.

PRICING

Heat molding and compression is included for FREE with all new heat-moldable skates purchased at House of Hockey.

For skates purchased elsewhere, our heat molding service is $20.00.

CCM Skate Compressor